OK, making a steamroller. First off, what are they?
Well, they are a device to add a carb to a joint to allow you to suck in air as the toker goes down and power up the hit. Building one is quite simple. Method 1 – Take a toilet-roll tube. Punch hole in middle of the “top” of the tube. Put joint in. Cover other end with hand and toke a coupla times, then remove hand while still inhaling. Blam. Method 2 – The green Smartie variant Get a Smarties tube (you DO have Smarties over there in WoDland right?) and a pen. Oh, and a packed joint WITH A CARD ROACH The roach should be about 3/4cm long. Now put two holes in the side of the smarties tube with the pen. One halfway down it, one at the non-lid end (not in the end, in the side of the tube before the end). Both holes should be in a line…i.e. on the same “side” of the tube. Now remove the lid, and squash the roached end of the joint into the hole at the end (the roach should spring back out a bit…anyway, it should seal. If not, use a little tape). Now toke through the tube with a finger
