My snore signal looks really different. What is wrong?
A. Set the filters as you normally would for EMG signals, (High frequency=120 Hz or higher; Low frequency =10 Hz). Set the sampling rate to 200 samples per second or your highest available setting, and save your montage. If your PSG does not have these settings, set to the closest value available. Q. I put a snore sensor on my patient’s neck, and an airflow sensor under his nose. I am unable to plug both into my Gemini adapter cable. A. Only Gemini sensors are capable of producing both airflow and snore signals. If you would like to use a snore sensor on the patient’s neck, and a separate airflow sensor on his face, you need two adapter cables. A yellow snore adapter cable is needed for the snore signal, and will plug into the snore channel of your head box. A red airflow adapter cable is needed for the airflow sensor signal. Q. Is it okay to put tape right over the snore sensor or the airflow sensor? A. Yes, taping across the snore sensor will not inhibit the signal. The airflow senso
Related Questions
- The medication I have received looks slightly different to what I used to buy, what?s wrong with it?
- The medication I have received looks slightly different to what I used to buy, what?s wrong with it?
- The medication I have received looks slightly different to what I used to buy, whats wrong with it?
- When I print the proposal, the font looks different than it does in the software. Whats wrong?
- When I print the proposal, the font looks different than it does in the software. Whats wrong?
- My snore signal looks really different. What is wrong?
