My controls aren being followed. Whats going on?
First, check if this is an EPS (extended period simulation) or steady state. If steady state, note that logical controls cannot be used and will be ignored. A control is designated as logical by the “evaluate as simple control?” check box, in the controls tab of the Controls editor window. If the model is EPS or if simple controls are used, then you should check your control sets. In the Controls editor window, click the control sets tab and ensure that the control(s) in question are included in your control set. Also, go to Analysis > Alternatives, expand the Operational alternatives, double click the one used in the current scenario (designated by the red check mark) and ensure that the correct control set is being used.
