My auger will not turn but the auger cycle light flashes on and off like it is cycling. What is happening?
The first issue could be that the combustion fan speed it not fast enough so to adjust we need to turn the small trim pot on the bottom right hand corner of the control board that says fan to the left. The dial should be as far counter clockwise as it will go. The second issue could be that you have an auger jam or the onset of one. To correct you need to open the front door of the stove and dig out the jam from the drop shute where the pellets fall out of the best is to take a long screwdriver or stiff wire to dig out the sawdust.
