I’m having trouble aligning a part. What might be wrong?
• When the drawing is improperly aligned with the part, you’ll know it. The holes and edges just won’t match. Pick “View All” and try again. These questions might help you figure out what’s wrong with the alignment. • – Are you looking at the same face on the drawing and the part? If you’re not sure, select “Mirror” and try aligning the part again. – Did FabriVISION recognize each entire pattern during scanning? If you watched asFabriVISION drew each pattern, did you notice if any one pattern was drawn in two sections? FabriVISION should finish each pattern before continuing to the next. – If FabriVISION draws a pattern partially—even if that pattern is later finished—this pattern cannot be used for alignment. If the scan created such patterns, you have two options. Select “Manual Align”, but don’t use any of the partial patterns for alignment. Or, move the part on the FabriVISION table and rescan. – If you’re aligning with edges, do the first two you picked intersect on the part? Edge
