Im have a Celeron/xxxMHz processor, whats the correct jumper settings?
• Refer to the Processor Settings section. Can I use the slot 1 Celeron processor? • No, this board only accepts the socket version of the Celeron (i.e., the PPGA370 [plastic pin grid array] version). What is the front side bus (FSB) of the Celeron/366/400/433/466/500/533 processor? • As of today (08/23/1999), all Celeron processors run at 66MHz FSB, regardless if it’s the slot 1 or PGA370 version. I’ve turned the system on, but I’m getting no power (i.e., power supply fan does not spin). • Make sure the cable from the case’s power switch is connected properly to the board’s power on jumper; refer to the motherboard manual. • Try reseating the ATX power connector to the motherboard. • Disconnect all the power connectors to your HDD, FDD, CD-ROM, etc. then try powering the system up. • Try replacing the ATX power supply. I have two USB ports in the back, how do I enable them? • Windows NT 4.0 currently do not support USB. • Windows 98 comes with native USB drivers. • Windows 95 (version
Related Questions
- I have a GigaDesigns 1.2GHz processor upgrade, and the jumper settings included in the manual don work at the speed they are supposed to. What are the correct jumper settings for my card?
- I just bought a zif processor and there were no jumper settings included. How do I set the speed?
- Im have a Celeron/xxxMHz processor, whats the correct jumper settings?
