I want to preserve what Ive done so far in a Cisco lab…how do I save my configurations?
There are three buttons that are important for you to know: “Cycle Break”, “Save”, and “Reset”. “Save” allows you to save the current configurations in your lab and “Load” will return the devices to that saved state. Maybe you’re unsure of the next configuration command and you want to be able to return to a safety point or, maybe, you want to try something outside the parameters of the lab and you will want to get back to where you left. If you “Save” the device configuration, perform the experimental step, and find that step to be unworkable, you can “Cycle Break” (if communications are completely lost) or “Reset” and then “Load” your saved configuration. Top If I start a Cisco lab and can’t finish it in the scheduled time frame, can I continue? Yes. Equipment configurations are automatically saved at the end of a session unless you choose to manually save one or more device configurations during the course of your lab. If you do perform a “Save” during a lab, you will need to manual
Related Questions
- I want to preserve what Ive done so far in a Cisco lab...how do I save my configurations?
- What are the supported configurations in conjunction with Cisco "extended fabric"?
- What are the supported configurations in conjunction with Cisco "extended fabric"?
- To Copy Configurations To and From Cisco Devices Using SNMP 13.1>Q: snmp ?
- To Copy Configurations To and From Cisco Devices Using SNMP 13.1>Q: snmp ?
- What is the best way to develop CCIE level network support contracts?
