i want to change the radio in a 1997 buick skylark. How does the old unit come out?
well, you gotta take the dashboard apart , the screws are located in many parts of the dash , if you are putting in a new head unit that has no plugs , you need to pull out the old unit , it may be screwed in thanks to GM’s theft protection , you need to cut the plugs off the ends , and connect the wires m the red and yellow wire on your head unit are your positive wire (red) and your memory cord , just connect both of them to your power wire , connect your ground wire (black) and plug in your antenna , after that you have nothing but speaker wires you connect then in sets like front left is one set with 2 wires and all the others are the same , after you strip and connect your positive and memory cords cap them off to prevent shorts , and connect your black ground wire to the black wire in the dash and cap it off as well , after you connect your speaker wires you need to either tape them or cap them , don’t leave any bare wire showing , put your unit back in the dash put your screws i
