I keep getting Event Loop Occured warnings what can I do to make them go away?
The short answer: Make sure the “Globally disable event loops” setting is un-checked in the system preferences, and the “Event Loops” setting in the instrument properties is checked. If it is already checked and you are still getting the warnings in that instrument, try unchecking and checking it. The Long Answer: As of v4.1, Reaktor has the ability to “Disable Event Loops”. When Event Loops are disabled, Reaktor will stop events at places in the signal chain where it thinks an event loop is occurring and issue a warning. The idea here is that if you have an instrument or an ensemble with an event-loop you may not be able to open it because the loop would cause Reaktor to crash. When you have the “Disable Event Loops” setting turned on, you’ll be able to open the instrument and correct the problem. The issue as of r4.1, however, is that Reaktor sometimes thinks there’s a bad (uncontrolled) event loop when there is not, and sends up these warnings all the time. This can be especially an
Related Questions
- Which specific event in histiory occured before the telephone, light bulb, gas power car and even the airplane was invented?
- Can I discard a Run Away I have in play to prevent damage from one Event, Edge, Location, or Situation as well as an attack?
- Have you thought about moving the entrance to the HHSD campus away from the curve on Levander Loop?
