I have trees and other objects in may lawn. How will it work with them?
Trees or other areas within the lawn that should not be accessible to the lawn mower are handled in one of two ways. If the object is rigid and at least six inches tall, the lawn mower simply bumps into them, as the bumper sensors will detect the small impact and cause the lawnmower to change direction. Other areas, like a flowerbed or swimming pool, are excluded from the cutting area by using the same wire as installed on the perimeter. The object is simply looped out during installation of the perimeter wire. The inbound and outbound leads of the wire used to loop out the object are installed right next to one another. This causes the signal in this section of the wire to cancel, allowing the mower full access around the obstacle, but keeping it out of the area excluded.
