I have the headlamp kit almost completely applied using the wet application method, but I can seem to get the edges to completely stick down. What am I doing wrong?
It is absolutely imperative that a hairdryer or heat gun is used in this area to seal the edges. The heat serves two purposes. First, it helps evaporate the remaining alcohol/water solution from under the edges, and second it makes the plastic more pliable so that it can contour to the edge of the light. Be careful if you are using a heat gun to warm the plastic. It takes only a small amount of heat to apply the material. If you apply too much heat you can damage the surface of the plastic.
Related Questions
- I have the headlamp kit almost completely applied using the wet application method, but I can seem to get the edges to completely stick down. What am I doing wrong?
- What mailing method does CIBT recommend for submitting my completed CIBT Passport Application Kit?
- Can I use the wet application method with vinyl paint mask?
