I have selected the correct Model for Dish Network System in the Setup Wizard, however I am not able to change the channels through Vulkano. Is this a Hardware problem?
Kindly Note: VULKANO IR Works on Remote Address 1. Kindly make sure your Dish Receiver is set to Address 1 to make VULKANO IR work with it. Dish Network System has an option of Remote Address Selection. Kindly make sure the Remote Address Selected on your Dish Receiver is 1. To find out what channel your remote control 1 is configured to, do this: • Press menu 2 times to get to system info • In the system info page the primary remote address followed by a Green TV symbol and says IR will tell you the channel your remote control one is configured. If the number of your Remote control 1 is not on channel 1, here is how to change it: • In the system info page press and hold the SAT button on your remote until all other modes are flashing, about 3 seconds. • Then press 1 on the number pad of your remote control • Then press 1 time the search button which is located at the # signal • Press the record button which is the red button • At this point you should see a number 1 in front of the Pr
