I have a BreezeNET Pro.11 system, and I wish to implement WEP. How do I do that?
A. Units before firmware 5.1.36 required the system operator to call Alvarion sales @ 760-517-3100 and obtain a password to enable WEP. Versions after 5.1.36 can have WEP enabled (Shared Key) in Installer mode. Q. I’ve got a problem with an access point which stops passing traffic to radios in one sector. It has 14 stations associated with it, and it will drop its connections to these stations one at a time. If I reset the access point it will start passing traffic to the station again. I have replaced the access point with another access point and the problem appears to be isolated to this one sector. What could cause an issue of this type? A. One of the features of the BreezeNET and BreezeACCESS system is that it ages out MAC addresses that have not communicated in some time. It seems to me that since you can still manage the SA’s and SU’s even in this state where no traffic can pass, that the problem is an ethernet-bridging problem. The AP uses an algorithm based on the numbers of e
