I can open the *.avi file in Digitize, RealCap and Capture, but I can open the *.avi file in the Trimmer. Something wrong ?
> ADI: Have you purchased the software license for the APAS? Or have you obtained the SITE KEY for the 30-Day trial? If not, you will not be able to perform analysis using the APAS. If you have obtained either the 30-Day Site Key or purchased the APAS software license then follow these steps. When you open the AVI file in the TRIM module, you must specify the folloiwng points: Start of trimming, End of trimming and the Synchronizing point. After these points have been specified, you should select the “SAVE TRIMMING” option. Then you should be able to open the “new” file in other modules. >2. When I open the Capture, It told me ” Failure to open Comm Connection”. After I press “Enter”, It told me “Problem connecting to VCR”. I am sure that I have opened the JVC-9800 Digital Video power and it works very well. I can see the image on the computer when I use the Ulead VideoStudio 4.0. > ADI: This is correct! This means that the computer is not connected to the Panasonic computer controlled
