I can install compute nodes and I have a Dell Powerconnect 5224 network switch, what can I do?
Here’s how to configure your Dell Powerconnect 5224: You need to set the edge port flag for all ports (in some Dell switches is labeled as fast link). First, you’ll need to set up an IP address on the switch: • Plug in the serial cable that came with the switch. • Connect to the switch over the serial cable. The username/password is: admin/admin. • Assign the switch an IP address: # config # interface vlan 1 # ip address 10.1.2.3 255.0.0.0 • Now you should be able to access the switch via the ethernet. • Plug an ethernet cable into the switch and to your laptop. • Configure the ip address on your laptop to be: IP: 10.20.30.40 netmask: 255.0.0.0 • Point your web browser on your laptop to 10.1.2.3 • Username/password is: admin/admin. • Set the edge port flag for all ports. This is found under the menu item: System->Spanning Tree->Port Settings. • Save the configuration. This is accomplished by going to System->Switch->Configuration and typing ‘rocks.cfg’ in the last field ‘Copy Running C
Related Questions
- When I install VPN Client, the Deterministic Network Enhancer Add Plugin Failed error is received. How is this error resolved?
- When I run the installnode command, the nodes reboot, but the network install process doesn start. Why?
- I can install compute nodes and I have a Dell Powerconnect 5224 network switch, what can I do?
