I am looking for the wires leading to the fuel injector. Where are they?
• The injector cable runs along the rear of the hump just in front of the saddle. • Remove the right and top plastic pieces that cover the hump. • The following picture shows the cable lifted into view after removing the cable tie holding it to the rear, curved frame member. • The picture beside it shows the two wires after the outer insulation has been stripped away. Is there a non-destructive way to hook up the wires without using the Wire Taps. i.e. I don’t want BMW to see it. Version 1: by Haakon #626 My non-destructive wiring is not something I am proud of. I just used stuff I had lying around. The narrow red connector that I use on the injector is widely used but I do not think you can get that type at a car accessories shop. That type is more commonly used on audio equipment and such. I will try to find both the male and female original connectors as used on the bike. With those, I could make a real nice extension wire to hook up the FN. Version 2: by Haakon #626 The Bosch deale
