How to Set up the Humidity Control ?
On incubators where the auto-Humidity feature is not fitted the humidity can be increased via filling the bottom tray with water. As relative humidity is directly proportional to the surface area of water, small receptacles may be placed on the floor of the incubator with different surface areas until the desired humidity level is obtained. On auto-humidity incubators the reservoir should be filled using distilled water to combat lime scale build up within the reservoir. Opening or closing the Humidity flap to various degrees can alter the humidity level to suit most incubation needs. If when the flap is fully open (white line is at three o’clock) the humidity is still not as high as you require then switch on the Humidity on/off switch. By turning the Humidity up/down switch this will increase the humidity level up to 100%. Once the on/ off switch is turned on there is a small heater situated under the water reservoir, which warms the water, and so assists in evaporation hence increas
