How to Operate the Temperature Control ?
Once your machine is sited, plug the Incubator into the outlet and turn on the main power switch. If digital readers are fitted these will light along with the power switch. Leave the incubator running for several hours to heat up and allow the internal temperature to stabilize. The ‘Thermo Light’ will be lit continuously while the incubator is heating up and will start to flash on/off as it reaches the set temperature. The temperature settings will be set either at or very close to 37.5° C in factory prior to shipment. The two knobs marked coarse and fine are your temperature controllers. The coarse knob should be used to adjust the temperature to “close to” the desired temperature and then the final adjustments made with the fine knob. Whenever making adjustments please ensure you check the temperature regularly, as the change does not reflect instantly. Each incubator is fitted with two additional safety thermostats. On the left hand side panel a mechanical safety thermostat is fitt
