Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How to configure boards with ISA interface?

April 26, 2017configure interface ISA

0

Posted

How to configure boards with ISA interface?

1 Answer

0

Posted

To configure C102/C104/C168 series and C114HI multiport board, you must use IO-IRQ.EXE under DOS. You may find IO-IRQ.EXE in following driver disks. – DOS driver disk – WindowsNT/95 driver disk IO-IRQ.EXE can be executed under the following operating systems. – MS-DOS or other compatible DOS – Windows95/98 DOS prompt Please note that IO-IRQ.EXE is not executable under WindowsNT DOS prompt due to I/O protection of WindowsNT. The procedure to configure 102/C104/C168 is as below. Power off PC. Set JP1=short for the Moxa board and insert it into the PC. Power on and enter DOS or Windows95. Run IO-IRQ.EXE. Please enter “A700” as CAP address and then configure I/O addresses, Interrupt Vector, and IRQ. Power off PC and set JP1=open. Reboot PC for driver configuration.