How to access to HDD files from a PC (and vice versa)?
3 ways are available: 1. Use removable rack (IDE connexion) The disk must be positionned to “master” mode in PVR-800, so in theory, your disk should be the first disk of the second IDE cable in your PC. If your rack is mounted in your PC, it must be connected at the end of the IDE cable if you let it to master mode. If it’s in slave position, the rack must be connected on the middle of the IDE cable. If you are obliged to set the position to master in the PVR-800 and slave in the PC, you’re obliged too to switch the jumper position of the disk each time. Note: you can set the rack to master mode and let the disk in its tray to master with a second HDD in your PC in slave mode. This configuration lets you access to your slave disk even if the main HDD is not plugged. Thanks to Fred.Eric and Nicolas68 for feedback on this. Attention: before remove the HDD from the PVR, the PVR-800 MUST BE in stand-by mode. Same for the PC, do not try to hot plug your IDE HDD, switch it off in first, then
