How is it installed in the duct work?
Bring the duct balloon and blower to a location near the access door. Remove it from the storage bag. Carefully feed the balloon through the access door opening to the work to the area where you want to install it. Run the inflation tube back out the access door near the blower. The balloon has anchor rings sewn into the top corners for lifting it in place if required. Most balloons less than 20’ high can be maneuvered in place during the inflation process without hoisting. Connect the inflation tube to the blower and then turn the blower on. As the balloon starts to inflate, it can be maneuvered into position by using the supplied grab handles. Installation time is usually less than 20 minutes, depending on balloon size.
Bring the duct balloon and blower to a location near the access door. Remove it from the storage bag. Carefully feed the balloon through the access door opening to the work to the area where you want to install it. Run the inflation tube back out the access door to the blower. The balloon has anchor rings sewn into the top corners for lifting it in place if required. Most balloons less than 20’ high can be maneuvered in place during the inflation process without hoisting. Connect the inflation tube to the blower and then turn the blower on. As the balloon starts to inflate, it can be maneuvered into position by using the supplied grab handles. Installation time is usually less than 10 minutes, depending on balloon size.
Related Questions
- I have installed a 92/80 mm fan duct in the front bezel of my case, but the front bezel is not perfectly flat. How would I modify the fan duct to fit the front bezel?
- Where can a System Sensor duct-mounted smoke detector be installed in relation to the duct?
- Can cable be installed in the duct or innerduct at the factory?
