How does RustStop electronic rust prevention work?
Q: How difficult is it to install a RustStop RS-5 unit? Can I do it myself? A: It is quick and simple for the “do it yourselfer” to install, but it is vital that it is installed correctly as incorrect installation can affect the efficiency. Installation (simplified): Mount the command module in the engine compartment with the attached adhesive tape. Mount the four sacrificial anodes termed “Rust Magnets” using the specially designed conductive adhesive tape to areas of the vehicle where most water is likely to collect or run. Two at the front of the vehicle (usually in the hood recess areas) and the other two at the rear in similar areas. Run wires from the command module to each Rust Magnet and attach. For more information click on: RustStop RS-5 Installation Instructions Q: Will RustStop RS-5 cause electrical shocks if a person touches the vehicle. A: No. RustStop RS-5 will not cause any electrical shocks by merely touching the vehicle.
