How does a gun homemade tattoo?
I make a tattoo gun homemade, but the only problem is the connection with the needle that uses a motor eraser, needle crusher keeps eraser Take the guitar string and bend a bit of the end down or up. Limar the tip of the pen to get the bronze ball, make the hole large enough to allow passage of the needle. Insert the needle into the pen. Take the toothbrush and cut the bristles making it about 4 “long. Heated in the center with a lighter and bent into a” 7 “and keep in place until stiff. Join / tape the pen needle Assembly for the toothbrush. Take the eraser of the pencil and push on the motor shaft, try to get as dead center as possible. Join the pen / needle / tooth brush to the motor / eraser Assembly, tape the brush to the motor. Take the bent part of the needle / Stirng guitar and stick it in the draft (important – the needle should be deliberately off-center). Finding an energy source. You can connect some batteries to a switch then contacts the engine. Hints The tattoo ink can b
