How do you use the (ap7860)disc brake caliper wind back tool?
I have not used one of these but I’ve looked this kit over and here is how I see using it. There is one thing that is a little tricky in this procedure you will need to be cautious about. I have this section highlighted as a precaution for you. Read through these so you know ahead of time what your going to need to watch for. 1. Remove both disc brake pads. 2. Remove the T-handle from the tool. I’m thinking that the retainers for the handle are threaded. 3. Slide the #1 plate onto the tool from the handle end. 4. Replace the T-handle. 5. Select the correct piston disk for your application. (See link below for a PDF of which disk is for which make of car) 6. Place the disk in the piston and then insert the pins on the end of the screw into the holes in the disk. 7. While holding the disk in place by pushing against it with the screw turn the hex nut (Not the handle) until the #1 plate comes to bear against where the outside brake pad rides. 8. Slowely turn the T-handle and watch the rub
