How Do You Submersible Well Pump Installation?
If you are trying to replace a submersible well pump first read my article about removing submersible well pump, it’s in the the resource section of this article. I broke it up into two articles because it’s a lot of information. Once you have the old pump out and have determined it needs replacing you can see the type and model pump that you need to buy. Wire the old pump directly to power source once you have it out to make sure it needs replacing and that the problem is not in the wire that ran down in to the well. If you determine that the water level is still the same as before ( I’m going to write an article on how to determine this in the future) measure the wire or safety rope that you used to pull the pump out to determine the length of the new pipe if it needs replacing, more than likely this is the case as the pvc pipe used on most installations is hard not to break on removal but the polyethylene pipe for the new pump installation is not expensive. When measuring for length
