How Do You Replace The Idler Arm In A Crown Victoria?
The Ford Crown Victoria uses a conventional parallelogram steering linkage system. The steering gear box is attached to the linkage by the pitman arm and center link. The idler arm supports the passenger side of the linkage, and the tie rods attach the linkage to the wheels. As the idler arm wears, the steering linkage moves vertically and the tires wear because of the unwanted toe change. Raise and support the vehicle using the floor jack and jack stands. Position the jack stands under the frame to prevent injury if the floor jack fails. Remove the cotter pin and the18mm nut attaching the idler arm to the center link with a 18mm wrench. Separate the idler arm from the center link by driving the tie rod separator between the two parts with several sharp blows from a large hammer. Pull the center link down as far as you can to make removing the idler arm easier. Hold the the idler arm to the frame bolts, hidden in the frame, with an 18mm socket and extension. Remove the retaining nuts h
