How Do You Replace An Oil Pump In A Geo Metro?
The oil pump is an essential piece of equipment that keeps your Geo Metro running. It lubricates the engine by keeping the oil circulating. Without this lubrication, the engine wouldn’t run. An oil pump is usually located in the oil pan. If you want to change the oil pump and replace it with a new one, roll up your sleeves and get ready for some dirty work. Drive your Geo Metro up onto ramps or lifts so you have room to work as you pull out the oil pump. You could also use a jack, but make sure you brace the front wheels so they don’t roll. In addition, set the emergency break firmly into position so the car doesn’t roll. Disconnect the negative battery cable on your Geo Metro. Drain the engine oil out into a pan then remove the water pump belt and pulley, alternator belt, body and bracket. Take out the air conditioning compressor and mounting bracket if your vehicle has one. Remove the timing belt and crankshaft pulley then disconnect the oil level gauge. Pull out the crankshaft timin
