How Do You Rebuild Nitro Rc Engine Assembly?
• You will need a little bit of oil (after-run oil, multi-purpose oil, etc.). Just do not use WD-40. • Start with the carburetor. Take all of your small pieces and start with the barrel. Put a small bit of oil on there and stick it back in. • Replacing the Barrel • Line up the channel with the screw hole. This is the idle stop screw that will line up with the channel to keep it from pulling out too far and pushing in too far. Put the screw in and crank it down. Down the barrel carb – you want to push it in until it stops and look for a tiny ½ mm gap. • Now, take your barrel spring – take your fingernail and help run it right over the lip that it attaches to. Pull it over, hold it down, and run your finger around the carburetor and it should lock in place. Now you can take your seal or boot which goes over all of that – get the edge of the boot over the lip for a nice, tight seal. • Next, take your throttle arm and put it back on. There should be a little mark that the set screw made so
