How Do You Prime A Shallow Well Pump?
Priming a well pump becomes a necessity when air has gotten into the piping going down into or out of the pump. This is because the pump creates a vacuum from the circulation of water, which is what helps to pull water out of the well through a special valve located at the bottom of the piping. Priming issues don’t normally occur with a shallow pump, but it is possible, and fixing it is not difficult. Turn the pump power off to prevent electrocution. Turn the valve to the water inlet to the closed position, and remove the plug from the pump impeller housing. It should be about an inch or so wide. Also remove the plug off the water inlet housing. It should be about a half an inch or so wide. Pour the water through the funnel into both openings, and reopen the inlet valve. Look for bubbles to come up. Add water until it is full. Return the plugs to their original positions, and turn on the power to the pump. Turn on the pump and look at the pressure display to see if it is rising. Go int
