How Do You Make An Archery Bow Press?
An archery bow press can be used to curve your own homemade archery bow or it can be used to repair a bow you already have. An archery bow is crafted from steel and is a piece of equipment that is used to shape the bow into the proper curve so that your archery shots always remain accurate. In a few hours, you can fabricate your own bow press which can later be affixed to a workbench. Put on the face shield; lay the 1100 x 20 mm hollow steel bar flat on the work bench. Measure 100 mm from the left edge of the bar: make a mark with the grease pencil. Repeat from the right edge and make a mark with the grease pencil. Use the protractor to make a line at a 45 degree angle on one of the 2 ft 40 x 20 mm hollow steel bars. Repeat on the second bar. Cut along the line to create an angle on each bar. Position the angled edge of the 40 x 20 mm on the grease mark made on the 1100 x 20 mm hollow steel bar: weld the piece into position. Repeat this on the opposite side where the grease mark is mad
