How Do You Make A Paper Beretta/Pistol/Gun?
• Get an 8.5 x 11 computer paper (looseleaf paper works fine) and roll that paper so that the diameter is very close to 1 cm. Tape both ends as well as the middle. • Take another sheet and roll the paper over the first pipe. Then tape both ends and the middle. Take out the first pipe when finished. • Get a sheet of paper and roll it over the second pipe and tape both ends and the middle. Take out the second pipe when finished. • Take the first pipe and cut a 2 inch square hole on the top, then repeat this with the second pipe so that both holes made are the same. • Take another piece of paper and fold it in half horizontally (left and right.) Fold the paper so that it fits in your hand but leaves room so that your index finger can reach the trigger. Staple both ends. Make sure that one end is bigger than the other so that the mag won’t fall out. • Take an index card and stuff it into the bigger side of the mag. • Hold the mag slot (make sure the mag is still in) at an angle, cut the re
• Get an 8.5 x 11 computer paper (looseleaf paper works fine) and roll that paper so that the diameter is very close to 1 cm. Tape both ends as well as the middle. • Take another sheet and roll the paper over the first pipe. Then tape both ends and the middle. Take out the first pipe when finished. • Get a sheet of paper and roll it over the second pipe and tape both ends and the middle. Take out the second pipe when finished. • Take the first pipe and cut a 2 inch square hole on the top, then repeat this with the second pipe so that both holes made are the same. • Take another piece of paper and fold it in half horizontally (left and right.) Fold the paper so that it fits in your hand but leaves room so that your index finger can reach the trigger. Staple both ends. Make sure that one end is bigger than the other so that the mag won’t fall out. • Take an index card and stuff it into the bigger side of the mag. • Hold the mag slot (make sure the mag is still in) at an angle, cut the re
