How Do You Make A Homemade Stun Gun?
A stun gun can be a useful self-defense weapon and, along with pepper spray, is the most common among civilians. Unfortunately, stun guns can be on the expensive side, usually running from $50 to $100. But you can build a homemade model for just the cost of a disposable camera: under $5. Use the screwdriver to remove the plastic casing from the camera. The entire front half should pop off easily. Remove the flash bulb carefully, making sure not to disturb the circuit board, the capacitor or any of the wiring. Locate the two terminals of the capacitor, which protrude on either side of where the flash bulb was fixed. Bridge these terminals to drain any charge. You can use the screwdriver for this, simply laying the blade across the wires so that it touches both simultaneously. Straighten the paper clip, and then use the pliers to clip it in half. Put a small hook in one end of each paper clip wire, and hook one wire around each terminal of the capacitor. Use the pliers to close the hook
