How Do You Make A Cantenna?
This article explains how to make an inexpensive homemade cantenna. A cantenna is an antenna made from a can that can amplify wifi signals from 5-22db in most cases. The cantenna also makes it possible to increase the distance of many wireless networks. In addition, there are many websites that can help you design and see examples of homemade cantennas. • Find a can that is about 4 inches wide in diameter and about 6 inches long. You may be able to solder several cans together to meet the length requirements. • Use the table below to calculate how far you will drill the hole for placement of an N type Female Chassis-mount connector. One side is N-female for connecting the cable from your wireless equipment, and the other side has a small brass stub for soldering on wire. These can be found at electronics stores internet suppliers. • Drill a hole in the can about 2 inches from the end of the can. • Widen the hole to accommodate the adapter. • Place the adapter in the hole and secure to
If you are electronically inclined, you can make an antenna for your Wi-Fi card to increase the reception of your wireless connection. In order to make a cantenna, you will need a bit of mechanical ability and an external Wi-Fi card with an external antenna connection. These can be found in electronics supply stores or on the Internet. Step 1 Remove the screw on the external antenna connection of your Wi-Fi card. If you have an antenna connected, carefully pull the metal end out from under the screw. If not, simply remove the screw and set aside for later. Step 2 Purchase a “N” connector at your local electronics store, making sure that it has four mounting holes, one in each corner, so that you can connect it to your cantenna. You will also need to purchase a “pigtail” of your desired length that has one N-male end. The other end will have to match to your Wi-Fi card, so if you are unsure, take it along to the electronics store and ask for help in your selection. Alternatively, if you
