How Do You Install Valve Seals In A 350 Engine?
The valve seals on your 350 engine might harden or break after years of service. A bad seal will lead to oil consumption and cause engine smoke at the tailpipe. You can service the engine and replace one or more valve seals yourself. However, before you begin, make sure you have all the tools necessary to perform the job and understand the procedure. Top Dead Center Step 1 Disconnect the black, negative battery cable using a wrench. Loosen the nut on the bolt holding the cable terminal to the post and lift the cable off the battery post. Step 2 Set the transmission in “Park,” if the vehicle is automatic, or “Neutral,” if it is manual, and apply the parking brake. Step 3 Follow the spark plug wire that connects to that cylinder toward the distributor cap and mark the distributor body with correction fluid just under the wire terminal. Step 4 Disconnect the same spark plug wire from the spark plug. Grab the wire boot with your hand and twist it from side to side as you pull the wire off
