How Do You Install Tongue And Groove Panelling?
To put up tongue and groove panelling it is actually pretty easy. You need a few special tools to make it look good. Install framing or blocking if required. This should be installed with a maximum of two feet on center. Make sure there is framing in all corners too. If you are putting a pattern in make sure you have framing where required. Start by snapping a straight line if you are working on a ceiling. For walls plumb the first board. Install board so the tongues is to the outside. Nail board through the tongue with a finish nail. You can also use an air gun that shoots finish or brad nails for this. It will speed up the process. When splicing bevel the end of board so it matches the v on side. You can square butt the boards together or splice with a 45 degree angle. Use your preference, both ways look fine when using kiln dried lumber. After you have your first row installed put next row up by sticking groove over the tongue. Tap tight with a block. You can also use a chisel or a
