How Do You Install Plumbing For A Wet Bar?
If a wet bar is placed in an area already served by (or having close access to) existing water lines (including the main water line as well as hot and cold water lines), installing the plumbing for a wet bar is much easier. For the purpose of this article, we will assume that this is the case. Shut off the water supply. (It is probably best to do this to the whole house while completing this project.) Open all faucets and allow the pipes to drain as much excess water as possible. Cut into the hot and cold water lines, using your pipe-cutting tool. Use the “T” fitting as a placement tool to mark where the water line will need to be taken out to accommodate new piping, and cut the section(s) out. Clean and smooth the cut ends of the pipes thoroughly. Measure the amount of plastic pipe you will need to run water lines from where you tapped into the water source to your wet bar area. CAREFULLY cut the plastic pipe, using a fine-toothed saw or hacksaw, to the desired lengths. Repeat Step 4
