How Do You Install Civic A Window Regulator?
The windows on a Honda CIvic are not only the glass panels themselves. Like other vehicles, the glass is held in place by a regulator that moves the window up and down at your control. To install a regulator for the window glass, you must get inside the door itself by removing its trim panel. In most cases where you need to install a window regulator, you must remove the old regulator from the door first. What you must disconnect to install a regulator depends mainly on whether the Civic uses power windows. Unplug the cable on the negative terminal for the car battery in the engine. This is especially needed if the Civic uses power windows or doors. Detach the manual window crank (if equipped) by removing its clip with a hooked tool; the clip is on the back end of the crank at the bottom pivot, running parallel to the handle. Pry off the trim cover in the inner door handle with a flat-bladed tool. Remove the mounting screws. Pull out the handle bezel and disconnect the door handle rod
