How do you install an amp into a 96 dodge neon?
You have to connect a power cable from the battery, and run it through the fire wall, to the amp. The most common places to put the amp, are under the front passenger seat, or mount it to the trunk side of the rear seat (so it can be accessed by pulling down the back seat. There is NO nead to connect the NEG side of the amp to the battery NEG post (infact that would be a BAD idea). Find a bolt near your placement of the amp, and run a thick cable from the amp NEG to this bolt. A good place under the seat is the bolts that mount the seats to the car, they are bolted to the frame and not the body so you will get a good ground. With the POS and NEG cables from the amp, its best to use thicker wires, because using speaker wire can cause the POS cable to over heat and catch fire. The third and final power wire to your amp is commonly called the REMOTE wire, and should be connected to the “remote antenna” wire that is in the wire harness on all newer after-market stereo decks. If you are con
