How Do You Install A Pool Pump Installation?
First, the return water can be connected by applying pipe sealant to the threads of the plastic nipple and screwing into the pump-intake port. Apply contact to cement to the ends of the remaining joints and slip them together. Turn them slightly to spread the cement evenly.
Then attach the return compression fitting. From the pool pump to the filter, attach new PVC pipe. To attach these pieces together, use sleeves and elbows. Use purple primer inside the edges of the sleeves and elbows and on the ends of the pipes. It will need to set up for a minute or two. Then you can put the glue in the same places and push them together.
Make sure you use a good-quality PVC adhesive. Turn the joints slightly before the adhesive sets up to spread it out evenly and then hold them together until the adhesive starts to set. Put the new PVC pipe together one at a time so you aren’t trying to hold pieces all over the place. Once your pipes are all installed, place the conduit adapter from the old pump onto the back of the new pump. Now the pump should be ready to go.
Read more: Installing a New Pool Pump | eHow.com http://www.ehow.com/how-does_4883009_installing-new-pool-pump.html#ixzz18ouNpRv5
When setting up a swimming pool, it is important to maintain clean water with good chemical balance. To achieve these results, it is critical to install a proper pool pump and pool filter. The pump moves the water from the pool through the filter and back into the pool. Using pool hose connections and pool hose clamps to hook the filter up to the pump and pool is fairly easy. Select a location for the pool pump. Install it as close to the filter as possible for maximum efficiency. The pool pump must sit level on the ground, well below the pool water level. To create a level spot for the pump place two large paving stones at the site, and set the assembled pool pump and filter on them. Use a leveling tool to ensure the two stones are level. Begin installing the pump by attaching one pump hose to the skimmer pipe below the skimmer basket on the side of the pool. Use a hose clamp, and tighten it with a screwdriver. Attach the other end of the hose to the pump and secure it with a hose cla
