How Do You Improve Automatic Transmission Performance And Reliability?
• Use teflon tape on the threads and screw the barbed fitting adapter(s) into the pump body. • Cut a 4″ piece of the soft tubing and use it to connect the hard tubing and pump suction barbed fitting on the suction side (IN) of the pump. • Assemble the soft tubing to the barbed fitting on the pump output side. • Wire the battery clips to the power leads of the pump. Observe proper polarity! Red is Positive (+) Black is ground or negative (-). • Check the transmission fluid level and top up if required. Drive the vehicle for 8-10 minutes to warm the fluid. • Park the car on a level surface and shut the engine down. • Feed the hard tubing into the dipstick tube of the transmission, make sure it bottoms in the pan if possible. • Attach the clips to the car battery and pump out 6 quarts or more of transmission fluid into waste container. Measure the amount removed. • Replace the amount of fluid removed with new fluid. • Drive the car for at least a week. Do this 3 times at weekly intervals.
