How Do You Convert A Wasteful Hot Burning Wide Mouth Chillum Into A Screened Long Stemmed One Hitter?
• Scrape the top half-inch or so of the interior of the mouth of the chillum, removing any remaining crud from past smoking history and/or achieving an interior diameter which matches the exterior diameter of the fat part of the socket wrench piece you will be using.’; } s += “”; document.write(s); return; } google_ad_channel = ‘+7733764704+1640266093+9911500640+9016233241+8388126455+8941458308+1258424658+7122150828’ + xchannels + gchans; google_ad_client = “pub-9543332082073187”; google_ad_output = ‘js’; google_ad_type = ‘text’; google_feedback = ‘on’; google_ad_region = “test”; google_ad_format = ‘250x250_as’; //–> • Position a metal-ring screen-support (or failing that, a hand-made ring of tinfoil) in quarter-inch hole (crater) of socket wrench piece, leaving 3/16″ (5-mm.) distance to top. (An equivalent to this ring piece can also be made by cutting, and bending around, a small segment of Mesh #40 screen as mentioned below.) • Drive pre-shaped screen carefully down into crater as
• Scrape the top half-inch or so of the interior of the mouth of the chillum, removing any remaining crud from past smoking history and/or achieving an interior diameter which matches the exterior diameter of the fat part of the socket wrench piece you will be using. • Position a metal-ring screen-support (or failing that, a hand-made ring of tinfoil) in quarter-inch hole (crater) of socket wrench piece, leaving 3/16″ (5-mm.) distance to top. (An equivalent to this ring piece can also be made by cutting, and bending around, a small segment of Mesh #40 screen as mentioned below.) • Drive pre-shaped screen carefully down into crater as far as it goes (about 3/16″ or 5-mm. deep). The sides of the screen should stick up 1/8″ (3-mm.) or to about 1/16″ from top opening. • Tap socket wrench piece carefully down into the mouth of the chillum so that it fits tightly either flush with the top of the chillum or sticking out barely a millimeter or two. Tape or rubber-glue can be used to narrow the
