How Do You Check An Unresponsive Ignition On A Murray Electric Start Lawn Mower?
• Check the battery. You must be certain the battery is in good condition and we will assume that this is the case. Still, even with a fully charged battery, the voltage has to go from the battery terminals into the cables, so as well as confirming the battery is “hot”, it is necessary to make sure both the positive cable connector is tight, and the ground cable and the frame grounding connection are tight and not corroded or shorted out.’; } s += “”; document.write(s); return; } google_ad_channel = ‘+7733764704+1640266093+9911500640+7416705818+8388126455+8941458308+8509902424+8509902424+9683278076+7122150828’ + xchannels + gchans; google_ad_client = “pub-9543332082073187”; google_ad_output = ‘js’; google_ad_type = ‘text’; google_feedback = ‘on’; google_ad_region = “test”; google_ad_format = ‘250x250_as’; //–> • Check the solenoid switch. After it is determined the battery is sending voltage through the cables, the next step in the circuit is the solenoid switch, usually located mount
• Check the battery. You must be certain the battery is in good condition and we will assume that this is the case. Still, even with a fully charged battery, the voltage has to go from the battery terminals into the cables, so as well as confirming the battery is “hot”, it is necessary to make sure both the positive cable connector is tight, and the ground cable and the frame grounding connection are tight and not corroded or shorted out. Loading… • Check the solenoid switch. After it is determined the battery is sending voltage through the cables, the next step in the circuit is the solenoid switch, usually located mounted on the frame near the starter motor in the engine compartment. This device contains an electromagnetic switch that closes contacts when it is energized by the ignition. It is about 2 inches by 1 1/2 inches, with two large brass studs for the starter cable, and two small screw studs for the ignition wires, and may be round, or oblong with rounded edges, and made of
• Check the battery. You must be certain the battery is in good condition and we will assume that this is the case. Still, even with a fully charged battery, the voltage has to go from the battery terminals into the cables, so as well as confirming the battery is “hot”, it is necessary to make sure both the positive cable connector is tight, and the ground cable and the frame grounding connection are tight and not corroded or shorted out. • Check the solenoid switch. After it is determined the battery is sending voltage through the cables, the next step in the circuit is the solenoid switch, usually located mounted on the frame near the starter motor in the engine compartment. This device contains an electromagnetic switch that closes contacts when it is energized by the ignition. It is about 2 inches by 1 1/2 inches, with two large brass studs for the starter cable, and two small screw studs for the ignition wires, and may be round, or oblong with rounded edges, and made of high impac
