How Do You Build An Electric Smoking Device?
From cheap materials found around the house, you can build a chambered smoking device that will produce huge amounts of smoke quite rapidly. • Start by cutting the soda bottle in half parallel to the ground and then cut into the open cut ends of the bottle about an inch or so. This will help you get the two pieces of soda bottle back together. • Find the direction arrow on the fan and with it pointing downward, insert the fan up into the top of the bottle and tape in place. Tape all around the edge of the fan to seal. • Poke a small hole on one side of the top or bottom, bottom is better, of the bottle and insert your switch. It should have a lock ring that screws onto the shaft that just went through the bottle; screw that on. Use washers if necessary to get a good fit. • Poke a hole in the cap of the bottle and insert the threaded metal tubing (or a bowl with a stem) into the cap. Screw your bowl onto the tubing. • Run the positive wire from the fan (usually red) to the switch, then
