How do I use the waiting period for a quantized loop switch to start a loop copy?
During the waiting periods for SwitchQuant=cyc and cnf, you have the opportumity to copy the current loop’s audio or time base into the loop you are going to. This is explained in the manual under SwitchQuant, and is done with the multiply and insert buttons, repectively. NextLoop does not seem behave as the manual says when SwitchQuant is on and the current loop was created using a Multiply. For example, suppose I create a 1-bar loop and then mutiply it into a 4 bar loop (consisting of 4 1-bar cycles). If I hit NextLoop, it switches to the next loop at the end of the current *cycle* and does not wait until the end of the whole loop, unlike what the manual says. Is there any way to get it to do what the manual says it should do? The manual is wrong on that point. What you are experiencing is indeed the way it works, not a bug. Quantized loop switches occur at the end of the current cycle, not the end of the whole loop. If you are using the new LoopIII 5.0 software, you will notice that
