How do I train Eyebot to accept some variation in the placement of the part to be inspected?
• “LEARN” the part in its fixed state. • Tap the camera (while in “LEARN”) and/or wiggle the part slightly (without getting your hand in the field of view). • Turn knob to “RUN”. • Pull out the part and then put it back in again. What is your Score? Did it drop significantly? If so, return to step #1 and repeat. • Once Eyebot is no longer complaining about a good part and that the Score is consistently high, then you should try pulling the part away and setting the decision threshold accordingly. • Make sure the Pixel Counter is on (you should have two gauges on the screen). • Make sure that there is always a part on the screen during the “LEARN” process, otherwise you will teach Eyebot that no pixels is acceptable.
