How do I test the serial example (PPP over uart) on the DM642 evm ?
This was tested on NDK 1.94 but applies also to NDK 2.x Since the user guide is not very thorough in describing the host / target setup, below are some more detailed instructions: Gather a null modem uart cable and connect the evm to the Pc. In the default factory settings, no additional hw configuration should be needed on the DM642 board 1 – Network settings on the PC side: On the Pc, go in windows, and choose start > network > network connections select the wizard ‘create new connection’ then select: setup an advanced connection > accept incoming connections check the box communication between two computers using com1 – choose the properties and select • general: port speed 115200 / flow control none • advanced: 8 bits / none parity / 1 stop bit do not allow virtual private connections – in the ‘user’ tab create a new user called ‘username’ and with password ‘password’ (without the quotes) note: if your pc settings are more restrictive for security reasons, and do not allow to use ‘
