How do I setup ports / virtual servers / port forwarding?
Login to your router at http://10.0.0.2. Click on Advanced Setup, then Virtual Servers on the menu on the left. Now input your ports as required. Public & Private ports usually stay the same. Your Host IP address is the static address of your computer, i.e. 10.0.0.x which will be using the ports, NOT your ISP (WAN-side) IP address. Make sure you choose the right protocol for each port (TCP or UDP). As you add a port, click on Add this setting, your port will be immediately added (but not yet ready for use), You cannot enter ranges of ports, these need to be done separately, and you are limited to a no more than 20 virtual servers. Once you have added all your required ports, click on Save Settings / Reboot to save the settings. Wait for 1-2 minutes for the router to reboot and then check the Virtual Servers page to see if the settings have ‘held’. If the settings don’t ‘stick’ then you may need to power off the router from the mains for 30 seconds, after clicking on ‘Save & Reboot’ and
