Important Notice: Our web hosting provider recently started charging us for additional visits, which was unexpected. In response, we're seeking donations. Depending on the situation, we may explore different monetization options for our Community and Expert Contributors. It's crucial to provide more returns for their expertise and offer more Expert Validated Answers or AI Validated Answers. Learn more about our hosting issue here.

How do I setup DCOSS for a simple loopback mode for testing?

April 26, 2017dcoss loopback mode Setup simple Testing

0

0 Posted

How do I setup DCOSS for a simple loopback mode for testing?

1 Answer

0

0 Posted

Configuring DCOSS for loopback mode differs slightly depending on the protocol being used. First, connect a crossover RJ-45 cable (the TX is connected to the RX and the RX is connected to the TX) to the DCOSS; one end of the cable to trunk 0, the other end of the cable to trunk 1 (this may differ depending on which DCOSS trunks you wish to loopback). CAS Protocols. The two trunks being placed in a loopback configuration must be configured with the same protocol and protocol configuration (using the DCOSS Protocol Configuration screen). After opening the trunks, use the DCOSS Manual Call Generation (1) screen to place a call on a desired timeslot. Use the DCOSS Manual Call Generation (2) screen to answer the call on the incoming timeslot (the opposite trunk). PRI ISDN Protocols. The two trunks being placed in a loopback configuration must be configured with the same protocol and protocol configuration (using the DCOSS Protocol Configuration screen). One side of the loopback must be conf