How do I set up my Softub spa?
1. Select a flat, level surface within 10 feet of an electrical outlet. 2. Lay the black lid straps down on the ground, crossing each other, like the letter “X”. 3. Set the lid strap combinations to 00 on all four of the strap buckles. 4. Center your Softub spa on top of the lid straps. 5. Place the lid on top of the Softub and connect all four lid straps. Adjust strap length if necessary to fit into the buckles. CAUTION: Pulling too hard on the lid straps might cause the plastic buckle clips to break. 6. Connect the Hydromate pump to your Softub by pushing the (2) blue rubber hoses and (1) clear hose onto the corresponding fittings on the tub. The pipes from the tub should slide inside the connecting hoses at least 1″. 7. Adjust the metal hose clamps into place (near each of the edges of the blue hose), and tighten them with a standard flat screwdriver. 8. If you purchased the T300+, you will also need to clip the gray wires together. This is for your low-voltage light inside the tub.
