How do I set the Outback S-Lite to display ground speed?
While in a guidance mode, press the down arrow twice to display the ground speed. Q: How long does it take the Outback S-Lite to attain a usable signal? A: It normally takes 1-3 minutes. The GPS signal will be acquired first displaying a yellow light. DGPS correction will then be acquired which illuminates a green light. For e-Dif, it takes 10 minutes to generate corrections. The vehicle can be in motion during this process, but will not be accurate until signals are acquired. If the Outback S-Lite seems to take longer than 1-3 minutes to attain a usable signal, the memory of the console may need to be deleted. Q: Does the Outback S-Lite use straight guidance only? A: No, the user may also use contour guidance. Contour guidance is a mode that allows the user to be guided based upon his/her previous pass. Q: Can I switch from Straight Guidance to Contour during the same job? A: The operator can switch back and forth between straight and contour modes. Since contour guidance follows the
